Reference design remotely locates image sensors up to eight meters away
Update Time: 2019-12-20 04:40:35
Lattice Semiconductor Corporation announced the Sensor Extender reference design that offers a low-cost approach to remotely locate image sensors up to eight meters away from the image signal processor (ISP) and transmit and receive video signals at resolutions that range up to 720p60 and 1080p30.
The reference design uses inexpensive low-cost Cat5E cable to carry high-definition video and to send I2C sensor control signals from the ISP during the vertical blanking period. Three twisted pairs carry the video and commands while a fourth pair provides power and ground to the remotely located sensors.
This solution serves applications that require image sensors to be separated from the image signal processor, which are often placed in tight spaces without room for adjacent ISPs to process the image. Typical applications include medical probes, large screen TVs with an integrated HD camera, surveillance domes, piping inspection ports, and point-of-sale scanners. The Sensor Extender may link a single sensor to an ISP or connect a number of sensors to a central processor.
Sensor Extender features
The reference design uses two Lattice MachXO2 low density FPGAs: one is placed next to the image sensor and the other is located just before the ISP. A single twisted pair CAT5E/6 cable connects the two.
The Sensor Extender solution offers a variety of interfaces (before serialization) for CSI-2, HiSPi, parallel, or sub-LVDS image sensors along with support for extending two or more image sensors. Additionally, the reference design allows parallel or serial ISP interfaces (after-deserialization). Designers can configure parallel interfaces to handle 1.8V, 2.5V, or 3.3V LVCMOS levels.
The reference design is tested with the Aptina MTMT9M024 and the Lattice HDR-60camera development kit’s base board.
Price and availability
Designers who already have Lattice’s HDR-60 Video Camera Development Kit can purchase the Sensor Extender kit; part number LCMXO2-4000HE-SEC-EVN. The price is $295.00 and is available now. The additional cost for the HDR-60 development kit is $425.00. For more information, please click on the SensorExtender link.
CPLD MachXO2 Family 2.5V/3.3V 32-Pin QFN >
Programmable Power Supply Monitoring, Se >
IC GAL WIEDER PROGRAMMIERBAR >
Ceramic Chip Capacitors / Standard C0G; >
High Performance E 2 CMOS In-System Prog >
CPLD - Complex Programmable Logic Device >